Williamson County · 14.8 miles from Brentwood
Hillside and terrace work in Leiper’s Fork
Land around Leiper’s Fork runs from flat stream terraces up steep, cherty hillsides, and the two call for different plans.
TL;DR
Leiper’s Fork is unincorporated Williamson County, about 15 miles from Brentwood. The ground near its center mixes Armour terraces, cherty Dellrose hillsides with a 16 percent median slope, and Huntington flood plain soil. Expect chert in the bucket on the slopes and deep, easy digging below them. Under the county’s policy, a lot under an acre can still need a Land Disturbance Permit when it is part of a larger common plan.
What comes out of the ground on a Leiper’s Fork hillside?
Chert, mixed all through the soil. Dellrose, at 12 percent of the sample points around Leiper’s Fork, is described by NRCS as cherty colluvium on foot slopes and steep hillsides: soil and broken stone that worked its way downhill over a long time. It is very deep and well drained, with moderately rapid permeability, and its slopes here have a median of 16 percent.
Chert is hard and sharp, and it doesn’t compact the way clay does. Dug out of a cut, it gets sorted into what can go back as fill and what has to be hauled off or set aside. Captina, at 8 percent, lays a thin silty mantle over weathered limestone and siltstone on the gentler upland spots, and that ground handles more like a lawn should.
Can a house or barn pad go on a Leiper’s Fork slope?
Yes, and the best spot for it is usually on the terraces. Armour, the most common series at 16 percent of the points, sits on stream terraces, foot slopes and valley floors with a median slope of 9 percent, and NRCS puts its limestone bedrock more than 5 feet below the surface. That is deep, workable ground for a pad.
Up on the Dellrose slopes, the same pad takes more cut and more fill. Everything placed goes in as 1-foot lifts rolled in, with the laser checking the grade as it rises, so the pad doesn’t come up high on one corner. Where a fill bank would run down too far, a block or stone wall holds it instead, with drainage and stone backfill behind it so water can’t build up against the face.
Can a small lot in Leiper’s Fork still need the county permit?
It can, if the lot is part of a larger common plan. Williamson County’s Land Disturbance Permit policy reaches below its one-acre threshold when the ground being worked belongs to a bigger plan of development. So a half-acre lot split from a larger tract that is being built out may be treated differently from a half acre standing on its own. A plat or deed, if you have one, often shows whether the parcel came out of a larger division.
Whether a given property counts is the county’s call, and we’d rather ask than guess. The rest of the county’s thresholds are laid out on our College Grove page. At one acre of disturbance, the state’s TNR100000 construction stormwater permit comes in too, whatever the county decides.
Do you clear overgrown ground around Leiper’s Fork?
Yes: trees, stumps, brush and the rock that comes up with them. Land clearing on a cherty slope is slower than on open bottomland, because the machines have to work across the hill rather than straight up it. On ground headed for a pad, the stumps come out whole so nothing is left to rot under the fill.
Burning brush from October 15 to May 15 takes a free state permit through BurnSafeTN.org, good only for the day it’s issued. Forestry mulching avoids the question on land that just needs opening up. Huntington soil, at 8 percent of the points, sits on flood plains at a 1 percent median slope, and that is where cleared ground stays the flattest.
The work, wherever the job is
Closest to Leiper’s Fork
- Thompson’s Station, TN7.5 mi
- Franklin, TN8.6 mi
- Fairview, TN9.4 mi
- Spring Hill, TN11.1 mi
- Bellevue, TN11.7 mi
- Kingston Springs, TN14.4 mi
Answers
Leiper’s Fork questions
Is the dirt in Leiper’s Fork rocky?
On the hillsides, yes. Dellrose soil there is cherty colluvium, so broken stone runs through every bucket. Lower down, Armour terraces are very deep, with limestone bedrock more than 5 feet below the surface. We plan the dig, and the hammer, around which of the two a job sits on.
Can a driveway be cut across a Leiper’s Fork hillside?
Yes. A driveway across a Dellrose slope gets a cut on the uphill side and compacted fill on the downhill side, placed in lifts so the edge holds. Water crossing it needs a way under or around. Our driveway prep covers the grading and the compacted base before any surface goes on.
Is the flat land in Leiper’s Fork good for building?
Often, but check what kind of flat it is. Armour terraces are very deep and well drained. Huntington soil is also very deep and well drained, but NRCS places it on river valley flood plains, so the flood status of the spot should be checked before a pad goes in.
Is Leiper’s Fork inside your service area?
Yes. It sits about 15 miles from Brentwood in a straight line, well within the 30 miles we cover. Send a photo of the slope, the overgrowth or the wet spot, and a rough size, and we’ll come back with a free estimate and what would need to be disturbed.