Cheatham County · 19.8 miles from Brentwood
Cutting into the Kingston Springs hills
Almost two-thirds of the ground around Kingston Springs sits on 40 percent slopes, and the soil under them changes from one hill to the next.
TL;DR
Kingston Springs, in Cheatham County, is about 20 miles from Brentwood. Hawthorne, Sengtown and Sulphura cover 65 percent of the sample points around its center, all at a 40 percent median slope. Sengtown is very deep, while the other two are moderately deep, so one hillside digs easily and the next hits rock. Retaining walls, benched cuts and driveways that climb are most of the work here.
Why does one Kingston Springs hillside dig easily and the next one hit rock?
Because the soils on them are built differently even at the same pitch. Sengtown, at 18 percent of the points, is very deep and well drained, formed in residuum of cherty limestone, so a cut into it can go a long way down in soil. Hawthorne, at 34 percent, and Sulphura, at 13, are moderately deep and somewhat excessively drained, formed over siltstone layered with limestone, chert and shale.
On a moderately deep soil, a wall footing or a house cut will usually reach rock. On Sengtown it may not. A picture won’t tell us which one a lot is on, so we say up front that rock is possible on any Kingston Springs hillside, and the hammer comes along. Excavation on these slopes is priced with that in mind.
How do you hold a cut slope in Kingston Springs?
With a wall, a bench, or both, depending on the room. A 40 percent slope drops 4 feet in every 10, so cutting a flat spot into it leaves a tall face behind. Somewhat excessively drained soils like Hawthorne shed water fast, which is fine for a yard but hard on bare dirt, because runoff carries it off before anything grows.
A retaining wall holds a tall face in the least space, built from a compacted base up, with drainage and stone backfill behind the block or stone so water can’t build up. Where there is room, benches split one long face into short ones that hold seed. Either way the job ends with final grading that keeps water from running over the top.
Can a driveway climb a hill in Kingston Springs?
Yes, but it usually has to cross the slope rather than run straight up it. On a 40 percent hillside, a straight driveway is too steep for most vehicles, so the line gets laid across the grade with a cut on the uphill side and compacted fill on the downhill side. The fill goes in 1-foot lifts rolled in, or the outside edge sags.
Water is the other half of a hillside drive. Anything that runs down the slope and across the driveway needs a way under or around it, or it will wash the base out. Driveway prep covers the cut, the fill, the compacted base and the drainage, ready for gravel or concrete. A gravel drive on a hill needs its base compacted as hard as a paved one, because loose stone creeps downhill under traffic.
Who calls us in Kingston Springs, and how do we start?
Mostly owners of settled homes on sloping lots. Kingston Springs has 2,791 people and 1,128 homes, with a median build year of 1992. Of those, 10 percent went up in 2010 or later, 13 percent in the 2000s and 26 percent before 1980. Older yards on hills tend to have walls that have started to lean and drains that no longer keep up.
Tennessee 811 marks the buried lines before anyone digs. We’re about 20 miles away in Brentwood, so a photo of the hill, the wall or the washout is the best way to start. A leaning wall is easier to rebuild while it is still standing than after it has dropped its load into the yard.
The work, wherever the job is
Closest to Kingston Springs
- Pegram, TN3.3 mi
- White Bluff, TN5.9 mi
- Fairview, TN6.9 mi
- Bellevue, TN7.8 mi
- Ashland City, TN12.8 mi
- Belle Meade, TN14.1 mi
Answers
Kingston Springs questions
Will you hit rock building a wall in Kingston Springs?
It is likely on some lots. Hawthorne and Sulphura, two of the main soils, are moderately deep over layered siltstone and limestone, so footings often reach rock. Sengtown is very deep and may not. We bring a hammer and say early on if rock changes the job.
Can a leaning wall in Kingston Springs be rebuilt?
Yes. A leaning wall usually failed for lack of drainage or a weak base. We take it down, dig out the base, compact new stone, set drainage behind it, backfill with stone and rebuild in block or stone. On a 40 percent slope, the base and drainage matter most.
Why does my Kingston Springs hillside wash out after storms?
Soils like Hawthorne shed water fast, and bare dirt on a 40 percent slope goes with it. Benching the slope, a retaining wall at the steepest part or grading that turns water along the hill instead of straight down it usually stops the washing. Seed holds better on short faces.
Is Kingston Springs within your 30-mile area?
Yes. Kingston Springs is about 20 miles from Brentwood in a straight line, well inside the 30 miles we cover. Send a picture and a short note, and we’ll come back with a free estimate and a clear account of what would be disturbed.