Williamson County · 6.1 miles from Brentwood
Dirt work on Nolensville’s newer lots
Most houses in Nolensville are young, and the ground under their lawns still shows how the builder left it.
TL;DR
Nolensville is one of the towns Brentwood Dirt Works names on its Facebook page, about 6 miles from Brentwood in Williamson County. With a median build year of 2012, most yards here sit on builder-graded clay, so the calls are mostly for low spots, wet side yards and drains. Gladeville and Talbott soils bring limestone near the surface in places, and a hammer on the excavator handles it.
Why does water stand in a new Nolensville backyard?
Usually because the topsoil was scraped off during construction and the clay left under the sod was packed hard by machines. Of Nolensville’s 4,538 homes, 61 percent were built in 2010 or later and another 14 percent in the 2000s. Lots graded that recently tend to have a thin skin of sod over subsoil that lets very little water down through it.
Talbott, the most common series around the town center at 22 percent of the sample points, is a clayey soil weathered from limestone with moderately slow permeability, according to its NRCS description. Rain that can’t sink in follows the surface, and wherever the finish grade is an inch or two off, it pools. We correct that with laser-checked regrading, and where the water has nowhere to go, a French drain gives it a route.
How close is limestone to the surface in Nolensville?
Close enough to matter on some lots and well out of reach on others. Gladeville, found at 10 percent of the points near the center, is described as very shallow and flaggy, formed from thin-bedded limestone. Talbott is moderately deep. Egam, at 15 percent, is very deep clayey alluvium in flood plains and depressions, so a trench there can run a long way without touching stone.
When the bucket does find a ledge, the excavator swaps to a hammer and breaks it out. Rock changes the time a trench or a footing takes, so we say so as soon as we know. Before any of it, Tennessee 811 needs 3 working days’ notice to mark the buried lines.
Can a low corner of a Nolensville lot be fixed without new sod everywhere?
Often, yes, when the problem is a few inches of grade rather than the whole yard. Egam soils sit in depressions with slopes under 2 percent, and a lawn laid over one of those low spots is where runoff comes to rest. We cut the sod back only where the grade has to change, set the new elevations with a laser, compact the added soil in lifts so it won’t sink by spring, and lay the turf back over it.
A swale between two houses is a common version of the same job. Its fall has to carry water past both foundations, and a missing inch over a long run will hold a puddle. Where the neighbor’s yard drains into yours, a buried line with its own outlet can be a cleaner fix than moving more dirt.
What does it take to get a Nolensville job on the schedule?
A picture and a few lines about what’s wrong. Nolensville is about 6 miles from our Brentwood base, one of the towns the company lists by name, and near enough that a look in person is easy when a photo doesn’t tell the whole story. The scope, and what will be torn up to do it, gets agreed before a machine comes off the trailer.
On a site disturbing an acre or more, the state’s TNR100000 construction stormwater permit applies. Jobs we’ve photographed are under recent work.
The work, wherever the job is
Closest to Nolensville
- Brentwood, TN6.1 mi
- Arrington, TN6.2 mi
- Antioch, TN7 mi
- La Vergne, TN7.7 mi
- Smyrna, TN8 mi
- Triune, TN9.3 mi
Answers
Nolensville questions
Does Brentwood Dirt Works take jobs in Nolensville?
Yes. Nolensville is one of the towns the company names on its Facebook page, about 6 miles from Brentwood. Grading, drainage, retaining walls, trenching, clearing and pad work all apply there. The quickest start is a photo of the problem, sent in for a free estimate, with a note on how long it has been happening.
Why is my Nolensville lawn spongy a day after rain?
Most likely the subsoil under it was compacted while the house was built, and water can’t get down through it. Talbott clay, the most common soil near the town center, drains slowly to begin with. Regrading the surface so it sheds water, or a French drain where it collects, usually ends the soggy patch.
Can you trench through limestone in Nolensville?
Yes. A hammer on the excavator breaks rock a bucket can’t, and pipe lasers keep the trench on grade once it’s through. Gladeville soils near Nolensville are very shallow over thin-bedded limestone, so some runs will meet stone early. We tell you when rock changes the length of the job.
How new are most homes in Nolensville?
Very new. Nolensville’s median home was built in 2012, and 61 percent of its 4,538 homes date from 2010 or later; only 7 percent are older than 1980. A yard that new usually sits on subsoil a builder cut, filled and compacted, which is why water tends to stay on the surface after rain instead of soaking in.