(615) 569-1679 Veteran-owned · Licensed and insured · Since 2021 brentwooddirtworks@gmail.com

Williamson County · 19.9 miles from Brentwood

Cherty ground and steep sides in Fairview

Fairview’s dirt carries stone, and plenty of its building ground sits on ridgetops with steep ground falling off the edges.

Brentwood Fairview 30 miles 20 10

TL;DR

Fairview is a Williamson County city about 20 miles from Brentwood. Baxter, a very deep clay full of chert, covers 48 percent of the sample points around its center, and Bodine slopes nearby run at a 30 percent median. That makes walls, benches and careful compaction common. Its 3,624 homes split almost evenly between pre-1980 houses and post-2010 builds, each with its own problems.

What is Baxter soil, and why does it matter in Fairview?

Baxter is the soil most Fairview jobs are dug in. Baxter turned up at 48 percent of the sample points around the center, and NRCS describes it as very deep and well drained, formed in fine-textured residuum of cherty limestone on hillsides and ridge tops. In plain terms, red clay with pieces of chert scattered through it.

That mix matters twice. The chert dulls teeth and makes a trench wall ragged, so utility trenching takes more cleanup than it would in clean clay. And clay with stone through it compacts unevenly, so fill placed on Baxter goes in thin lifts, rolled each time, to keep a pad or a wall base from moving later. Its median slope here is 9 percent, gentle enough for most pads.

How steep do Fairview lots get?

Steep enough on the edges to need walls. Bodine, at 7 percent of the points, has a median slope of 30 percent and is described as very deep, somewhat excessively drained gravelly soil on sharply dissected uplands. Sengtown, at 11 percent, sits at 16 percent. Those are the slopes that fall away from the ridgetop lots.

A pad or yard pushed out toward one of those edges needs its fill held. A retaining wall of block or stone does that, set on a compacted base with drainage and stone backfill behind it, and finished with grading that turns water away from the top. Where there’s room, benches cut into a long slope break it into steps that hold seed and slow runoff. Bodine’s gravel drains quickly, which suits a wall’s backfill but leaves a bare face washing until something takes root on it.

What does a Fairview house from the 1970s need compared with one from 2015?

Different things, and Fairview has plenty of both. Of the city’s 3,624 homes, 24 percent were built before 1980 and 25 percent in 2010 or later, with 16 percent from the 2000s and a median year of 1997. The population is 10,009.

The older houses tend to have mature trees close in, roots in the original drain lines and gutters that empty against the foundation. Those call for tree and stump removal and new drain runs. The newer ones more often have builder grading that left low spots or a yard draining toward the house, and those call for regrading or a French drain. Either way, a picture tells us which kind of job it is. The most useful one shows where water stands after a rain, or which tree sits closest to the house.

What has to happen before a Fairview dig?

Tennessee 811 marks the buried lines, and it needs at least 3 working days’ notice before anyone digs; its ticket lasts 15 calendar days. At an acre of disturbance or more, the TNR100000 construction stormwater permit is required, and on Fairview’s ridges and hillsides the clearing counts toward that acre.

Fairview is about 20 miles from our Brentwood base, so a photo first saves a trip. Say whether the work is near a property line or a ditch, because both limit where the dirt can go. On Bodine ground, where the median slope runs 30 percent, tell us how a machine would reach the work, since access decides which machine comes.

Answers

Fairview questions

Is there chert in the ground in Fairview?

Yes, a lot of it. Baxter, the most common soil around Fairview, formed from cherty limestone, and Bodine on the steeper slopes is gravelly with chert. It digs, but it wears on equipment and leaves rough trench walls. It also needs careful compaction when used as fill.

Can you build a level yard on a Fairview ridgetop?

Usually. Baxter ground on the tops has a median slope of 9 percent, which grades out without much trouble. The edges are the hard part, where slopes drop off at 16 to 30 percent. Fill pushed toward them needs a retaining wall or benching to stay put.

Do older Fairview homes need new drain lines?

Often. About a quarter of Fairview’s homes were built before 1980, and drain lines that old tend to crack or fill with roots. We find the line, dig to the trouble and replace the run, with 811 called first. Gutters dumping against the foundation get tied into the new line.

How long does a Fairview job take to get started?

It starts with a picture and a free estimate. After that, Tennessee 811 needs at least 3 working days to mark lines. Fairview is about 20 miles from Brentwood, inside the 30 miles we cover.

Don’t wait until it gets worse

Send us a picture. Get a free estimate.

A phone photo of the yard, the wall or the wet corner tells us most of what we need before anyone drives out.

Call Free Estimate