Cheatham County · 23.3 miles from Brentwood
High ground and low ground in Ashland City
Ashland City splits into steep hillsides and flat bottomland, and the work on each looks nothing alike.
TL;DR
Ashland City, in Cheatham County, is about 23 miles from Brentwood. Hawthorne covers half the sample points near its center at a 40 percent median slope, while gravelly Ennis soil holds the flat flood plain at 2 percent. With 32 percent of its 2,299 homes built in 2010 or later, it is the newest of the Cheatham County towns we cover, so builder-graded yards come up as often as hillside walls.
Why is Ashland City ground so different from one lot to the next?
Because the town sits on two kinds of land. Hawthorne, at 50 percent of the sample points, is moderately deep, somewhat excessively drained soil on uplands with a median slope of 40 percent here. Sulphura, at 15 percent, is the same pitch on highly dissected uplands. Together they make up the hills.
Below them, Ennis covers 18 percent of the points with a median slope of 2 percent: very deep, gravelly alluvium on flood plains and along drainageways, with moderately rapid permeability. A lot on the hill will need walls or benches and probably meets rock. A lot on the flat will dig easily and drain fast, unless it sits on a patch of Beason, the wetter terrace soil.
Do newer Ashland City homes have grading problems?
Some do, and the town has a fair number of new homes. Of Ashland City’s 2,299 homes, 32 percent were built in 2010 or later and another 22 percent in the 2000s, with a median year of 2002. Only 22 percent are from before 1980. The population is 5,424.
Newer lots often come with topsoil stripped during construction and a compacted layer under the sod that water can’t soak through. On the hills, that leads to runoff and washing; on the flats, to puddles that won’t leave. Regrading with a laser sets the surface so water moves off and away from the house, and the soil we add is compacted in lifts so the fix doesn’t sink. Downspouts that empty onto compacted ground make it worse, and they can be piped to the same outlet.
Which low-lying Ashland City yards need a drain?
The ones on Beason soil, mostly. Beason, at 4 percent of the points, sits on low stream terraces with a median slope of 2 percent, and NRCS rates it somewhat poorly drained, formed in fine-textured alluvium. Somewhat poorly drained ground stays wet near the surface for long stretches of the year, and no amount of surface grading on a 2 percent slope will dry it out.
A French drain set into that wet layer and run to an outlet takes the water away underground, and a sump pump can take over where the outlet would have to run uphill. Ennis ground nearby drains well on its own, so the wet yard and the dry one can be neighbors, and the Ennis lot rarely needs any help at all. Flood plain land should also be checked for flood status before any pad goes on it.
What happens before digging starts in Ashland City?
Two things: the estimate and the locates. We’re about 23 miles from Ashland City in Brentwood, and a picture is the way in for a free estimate. The scope, and what will be torn up to do it, gets agreed before the work is booked. Tell us whether the lot is on the hill or the flat, because that changes which machines come.
Tennessee 811 needs at least 3 working days to mark the buried lines, and the ticket holds for 15 calendar days. On a job disturbing an acre or more, the state’s TNR100000 construction stormwater permit applies.
The work, wherever the job is
Closest to Ashland City
- Joelton, TN8.3 mi
- Pegram, TN10.6 mi
- Whites Creek, TN11.3 mi
- Kingston Springs, TN12.8 mi
- Bellevue, TN14 mi
- Belle Meade, TN14.6 mi
Answers
Ashland City questions
Is the soil in Ashland City rocky or soft?
Both, depending on the lot. Hawthorne on the hills is moderately deep over siltstone and cherty limestone, so rock is often in reach. Ennis on the flat is very deep, gravelly alluvium that digs easily. A picture of the lot tells us which one we are planning for.
Why does my new Ashland City yard puddle?
Usually the subsoil was compacted during construction and the finish grade has a low spot. On flat Ashland City lots, a few inches makes the difference. Regrading the surface with a laser usually fixes it, and a French drain handles water that has nowhere else to go.
Can you build a wall on an Ashland City hillside?
Yes. On slopes near 40 percent, a block or stone wall goes in on a compacted base, with drainage and stone backfill behind it and the grade finished above it. Hawthorne is moderately deep, so the footing often meets rock, and the excavator’s hammer handles it.
How far is Ashland City from your base?
About 23 miles in a straight line from Brentwood, inside the 30 miles we cover. Send a photo of the wet spot, the slope or the wall, and we’ll come back with a free estimate and a plain list of what the work would disturb.