(615) 569-1679 Veteran-owned · Licensed and insured · Since 2021 brentwooddirtworks@gmail.com

Robertson County · 29.6 miles from Brentwood

Silty ground and slow drainage in Greenbrier

Greenbrier’s ground looks gentle, but a dense layer under some of it keeps water near the surface long after rain.

Brentwood Greenbrier 30 miles 20 10

TL;DR

Greenbrier, in Robertson County, is about 30 miles from Brentwood, at the outer edge of our area. Mountview silt covers 30 percent of the sample points near its center at an 8 percent median slope, and Dickson soil, at 12 percent, has a slowly permeable fragipan. Those two explain most wet yards here. Bodine slopes at a 30 percent median bring the steep spots, and 28 percent of the homes date from the 2000s.

Why does a Greenbrier yard stay wet when it looks flat enough to drain?

Often because of a fragipan. Dickson, at 12 percent of the sample points around Greenbrier, is a very deep, moderately well drained soil with a slowly permeable fragipan in the subsoil, formed in a silty mantle 2 to 4 feet thick over limestone residuum. Its median slope here is 4 percent. Water soaks into the silt, hits the dense pan and stops, so the yard stays soft for days.

Grading the top won’t reach water that sits a couple of feet down. A French drain cut into the wet layer and run to an outlet does. Where the water is reaching a crawlspace or basement, a sump pump may be part of the fix, and gutters tied into a buried line keep the roof water off the problem altogether.

What is Mountview soil like to build on?

Good, if it is worked at the right moisture. Mountview is the most common series around Greenbrier, at 30 percent of the points, with a median slope of 8 percent. NRCS describes it as very deep, formed in 2 to 3 feet of silty mantle, presumably loess, over limestone residuum or old alluvium, and well or moderately well drained.

Silt compacts well when it is damp and turns to mush when it is wet. A building pad on Mountview gets its fill in thin lifts, each rolled before the next, on days dry enough for the roller to do its job. The laser sets the top and the fall around it, so water leaves the pad instead of soaking back under it.

Where do the steep spots around Greenbrier come from?

From Bodine soil, mostly. Bodine makes up 18 percent of the points and has a median slope here of 30 percent. NRCS describes it as very deep, somewhat excessively drained gravelly soil weathered from cherty limestone on sharply dissected uplands. Where the gentle Mountview ground breaks off, Bodine is usually what it breaks into.

A yard or a pad pushed toward one of those edges needs its fill held. A retaining wall in block or stone does that, with drainage and stone backfill behind it. Sengtown, at 16 percent of the points, is very deep and cherty but sits at a gentle 8 percent median here, so it digs more like Mountview than Bodine. Gravelly Bodine sheds water fast, so the danger on those slopes is washing rather than standing water.

Is Greenbrier inside your service area?

Just. Greenbrier is about 30 miles from Brentwood in a straight line, at the outer edge of what we cover, and our only Robertson County town besides Ridgetop. Clear pictures help us plan a job that far out. For a wet yard, take them while it is wet; a photo from a dry week hides the problem.

Greenbrier has 6,971 people and 2,622 homes, with a median build year of 1997. Some 28 percent were built in the 2000s, 16 percent in 2010 or later and 20 percent before 1980. Tennessee 811 marks the buried lines at least 3 working days ahead of any dig there.

Answers

Greenbrier questions

Does Greenbrier soil have a fragipan?

Some of it does. Dickson soil, mapped at 12 percent of the points around Greenbrier, has a slowly permeable fragipan in the subsoil. It holds water near the surface after rain. A French drain set into that layer, with a proper outlet, is the usual fix.

Can you fix a soggy backyard in Greenbrier?

Usually, yes. If the problem is a low spot, regrading with a laser moves the water off. If the water is sitting on a dense layer below the surface, a French drain is needed. A picture taken the day after rain helps us tell which one it is.

Is Mountview silt good for a building pad in Greenbrier?

Yes, when it is compacted right. Mountview is very deep with a silty mantle 2 to 3 feet thick. It compacts well at the right moisture and poorly when wet, so fill goes in thin lifts rolled in on dry days, with the grade checked by laser.

Will you travel to Greenbrier for a small drainage job?

Yes. Greenbrier is about 30 miles from Brentwood, at the edge of our area, so a picture first helps us plan the trip. Estimates are free, and the scope, along with what will be disturbed, is agreed before the work starts.

Don’t wait until it gets worse

Send us a picture. Get a free estimate.

A phone photo of the yard, the wall or the wet corner tells us most of what we need before anyone drives out.

Call Free Estimate