(615) 569-1679 Veteran-owned · Licensed and insured · Since 2021 brentwooddirtworks@gmail.com

Bedford County · 28.6 miles from Brentwood

Pads, trenches and drains in Unionville

Unionville, 28.6 miles out in Bedford County, is unusually uniform underground: more than half the ground sampled there is one soil, Talbott.

Brentwood Unionville 30 miles 20 10

TL;DR

Unionville is a Bedford County community 28.6 miles from Brentwood, with 1,275 people and 505 homes. Talbott, a moderately deep clay over limestone, covers 54 percent of the points sampled near its center at a median 4 percent slope, with deep Bradyville soils at 15 percent. That ground suits pads and trenches, with rock a real chance at footing depth and wet spots on the poorly drained Eagleville and Agee flats.

What does Talbott soil mean for building in Unionville?

Firm clay to dig, with limestone waiting below it. Talbott is described as moderately deep and well drained, formed in clayey residuum weathered from limestone, with moderately slow permeability. In soil-survey terms, moderately deep puts bedrock within roughly 20 to 40 inches, about where a footing, a water line below frost or a drain trench wants to go. Around Unionville, that soil covers 54 percent of the points sampled.

The gentle grade helps. At a median slope of 4 percent, a pad on Talbott clay needs only modest cut and fill, and the clay compacts well in 1-foot lifts. Where the cut reaches rock, a hammer opens it. Bradyville, at 15 percent of the points, is a deep soil from limestone and gives more room before rock.

Can you run a water line or power out to a barn in Unionville?

Yes, that is utility trenching: water, sewer, electrical and plumbing lines, laid at depth and on grade, with pipe lasers to hold the fall and GPS locators to find what is already buried. On a Talbott tract the trench will usually be in clay most of the way, with stretches of limestone that need the hammer, so the route is worth choosing with the rock in mind.

Before any of it, Tennessee 811 marks the existing lines. The law wants at least 3 working days’ notice, and the ticket stays valid for 15 calendar days, which a long trench across acreage can outlast if rock slows it. The tolerance zone is the width of the marked line plus 2 feet each side, and inside it the digging slows down and gets careful.

Where does water collect around Unionville?

On the flats, where Eagleville and Agee soils lie. Eagleville, at 7 percent of the points sampled, is somewhat poorly drained clayey alluvium over limestone bedrock, on floodplains with a median slope of 1 percent. Agee, at 5 percent, is very deep, poorly drained and very slowly permeable, on broad flats in limestone valleys. Both stay wet near the surface for long periods.

A barn or house on that ground needs its pad raised and its runoff led away, and a yard on it may need a French drain or a sump. A building pad placed on the Talbott rise beside the flat is drier from the start, which is a strong argument for choosing the site before clearing it.

Is Unionville too far out for Brentwood Dirt Works?

No: Unionville is 28.6 miles from Brentwood in a straight line, close to the outside of the 30 miles the company covers. Its homes span the decades, with a median build year of 1989, 23 percent before 1980 and 13 percent since 2010. Chapel Hill, in Marshall County, has its own page. A picture of the site and a rough sketch of where the barn, house or line should go is plenty to start a free estimate.

Two statewide rules apply to any job there: TDEC’s TNR100000 construction stormwater permit at an acre or more of disturbance, and a free BurnSafeTN.org permit for burning clearing debris between October 15 and May 15.

Answers

Unionville questions

How deep is the rock in Unionville, TN?

Across most of the area, moderately deep. Talbott soil, at 54 percent of the points sampled near Unionville, is clay over limestone with bedrock usually within a few feet, close enough for footings and trenches to reach it. Bradyville, at 15 percent, is deeper. Each site varies, so a test dig on the actual pad location settles it.

Is a barn pad in Unionville built differently from a house pad?

Not in how it is built. Both start with stripping topsoil, then cut and fill to grade, fill placed in 1-foot lifts and rolled, and a laser-checked finish. The difference is what sits on it: a house pad follows a builder’s plan and slab elevation exactly, while a barn pad is set to the owner’s layout and drainage.

Can low ground near Unionville be drained for a yard?

Partly. Agee and Eagleville soils on the Unionville flats are poorly or somewhat poorly drained clays, and no drain makes them as dry as upland ground. A French drain with a real outlet, a raised grade around the house, and swales to move surface water can make a yard usable and keep water off the foundation.

Do you take jobs in Unionville and Bedford County?

Within 30 miles of Brentwood, yes. Unionville is 28.6 miles away in a straight line, so it falls inside that area, though near its edge, and parts of Bedford County farther south do not. Pictures of the site and the address are enough to start a free estimate.

Don’t wait until it gets worse

Send us a picture. Get a free estimate.

A phone photo of the yard, the wall or the wet corner tells us most of what we need before anyone drives out.

Call Free Estimate