(615) 569-1679 Veteran-owned · Licensed and insured · Since 2021 brentwooddirtworks@gmail.com

Rutherford County · 21 miles from Brentwood

Rock, walls and trenches in Rockvale

Shallow limestone soils cover more than a third of the ground sampled around Rockvale, and most of its homes went up after 2000.

Brentwood Rockvale 30 miles 20 10

TL;DR

Rockvale is an unincorporated part of Rutherford County, 21 miles from Brentwood, with 1,611 people and 620 homes, 85 percent of them built since 2000. The Gladeville and Barfield series, both shallow soils over limestone, cover 38 percent of the points sampled near its center, and Talbott clay another 23 percent. Expect the hammer on most digs, retaining walls on 9 percent grades, and a separate county application for the walls.

How close to the surface is the rock in Rockvale?

Close, across much of it. Gladeville, at 32 percent of the points sampled around Rockvale’s center, is described as very shallow and flaggy, formed from thin-bedded limestone, and Barfield, another 6 percent, is a shallow soil from limestone. On those two series, a shovel finds rock quickly. Talbott, at 23 percent, is deeper clay, but still only moderately deep before limestone.

For digging, that means a hammer on the excavator for most excavation, and an estimate that allows for breaking and hauling stone. Thin-bedded rock tends to come up in flat sheets rather than boulders, which makes it easier to load once it is broken. Egam, a very deep floodplain clay at 4 percent, is the rare spot where a dig stays in soil.

Do I need a permit to build a retaining wall in Rockvale?

Rutherford County has a separate one for it. The county’s Building Codes Department, at 1 South Public Square in Murfreesboro, takes a Retaining Wall Permit Application of its own, apart from any grading permit. When a wall is planned for a Rockvale lot, that application belongs on the schedule, and the county’s land disturbance page is where the grading side starts.

Walls come up often on ground like this. The median slope on the Gladeville and Talbott points is 9 percent, and a level patio, pad or driveway turnaround on that grade needs either a long bank or a wall. Every retaining wall goes in the same order: excavation, compacted base, drainage, stone backfill, reinforcement and final grading. In shallow rock, the excavation step can mean cutting the base into limestone.

What does a new Rockvale lot hide under the sod?

Often, a thin skin of topsoil spread over rock and compacted clay. Eighty-five percent of Rockvale’s homes went up in 2000 or later, 59 percent in the 2000s alone, and only 3 percent predate 1980. On shallow ground, builders commonly grade a lot down close to rock and spread back whatever topsoil was saved, so a lawn can sit just inches above limestone.

That shows up when an owner tries to add something. A French drain trench hits a ledge, or a line to a shed stops short. The answer is the same each time: dig with a hammer ready, and plan drains around the rock rather than hoping to go under it. Trenching for a water line or power to an outbuilding works the same way, with pipe lasers holding the grade once the rock is open.

Where does the water go on a Rockvale lot?

Downhill fast, then nowhere. Barfield, at 6 percent of the points, is a shallow soil described with medium to very rapid runoff, and the Gladeville ground beside it has little depth to hold rain, so storms move across the surface quickly. At the bottom, that water meets Talbott clay with moderately slow permeability, or Egam floodplain clay at a median 2 percent slope, and there it sits.

On a newer Rockvale lot, that tends to show up as a wet strip along the back of the house or between two homes. A French drain set into the clay, with a solid line to an outlet, catches what the grading cannot. Before any trench opens, Tennessee 811 marks the buried lines, and the ticket runs 15 calendar days. Rockvale is 21 miles from Brentwood in a straight line; Eagleville and Murfreesboro have pages here too.

Answers

Rockvale questions

Why is it so hard to dig a post hole in Rockvale?

Because limestone sits close to the surface across much of Rockvale. The very shallow Gladeville series covers 32 percent of the points sampled near its center, with flaggy slabs through the soil and bedrock just under them. A hand auger stops quickly on that, while an excavator with a hammer gets through it.

Can a French drain go through rock in Rockvale?

It can, but it is often better routed around it. Where a drain line must cross a ledge, a hammer breaks a trench through. Where the rock is wide and flat, the drain can sit higher, in a shallower trench with more gravel, as long as it keeps a steady fall. The goal is getting water to an outlet, not reaching a set depth.

Are Rockvale homes mostly new construction?

Mostly, yes. Fifty-nine percent of Rockvale’s 620 homes were built in the 2000s and 26 percent in 2010 or later, while only 3 percent predate 1980. The median year built is 2006. Yards there tend to have builder grading, thin topsoil and young trees, rather than the old drain lines found around older houses.

What does Barfield soil mean for a Rockvale yard?

Fast runoff and shallow rock. Barfield, at 6 percent of the points around Rockvale, is a shallow limestone soil, well to excessively drained, with medium to very rapid runoff on slopes. On a lot with Barfield ground uphill, water arrives quickly at whatever sits below it, so the grading has to give it somewhere to go.

Don’t wait until it gets worse

Send us a picture. Get a free estimate.

A phone photo of the yard, the wall or the wet corner tells us most of what we need before anyone drives out.

Call Free Estimate