(615) 569-1679 Veteran-owned · Licensed and insured · Since 2021 brentwooddirtworks@gmail.com

Rutherford County · 22.7 miles from Brentwood

Clearing and grading land in Walterhill

The census counts just 44 homes in Walterhill, so this page is about its land: what is under it, and what it takes to clear, grade and cross.

Brentwood Walterhill 30 miles 20 10

TL;DR

Walterhill is a small unincorporated place in Rutherford County, 22.7 miles from Brentwood, with 113 people counted. Its ground is split four ways: red Cumberland clay at 25 percent of the points sampled, then Talbott, Gladeville and Bradyville at 12 to 14 percent each. That mix means deep clay and shallow limestone on the same tract. Clearing or grading more than an acre brings in Rutherford County’s land disturbance permit.

Why is the dirt in Walterhill so red?

That red is the Cumberland series, the most common soil around Walterhill at 25 percent of the points sampled. Its official description gives it a dark reddish brown silt loam on top and dark red clay below, a color that comes from iron in long-weathered clay. On the points sampled here it lies on gentle ground, at a median slope of 4 percent.

For grading, Cumberland clay works well when moist and turns hard when it dries. It compacts well in lifts if the moisture is right, which makes it reasonable pad material. It also softens and ruts under traffic when wet, so a gravel drive over it needs enough compacted stone base that the clay cannot pump up through the surface. Driveway prep on red clay is mostly about that base, plus ditches that keep water from standing beside it.

Is there rock under Walterhill land?

On part of it. Gladeville, a very shallow, flaggy soil over thin-bedded limestone, covers 13 percent of the points sampled, at a median 9 percent slope, and Talbott, moderately deep clay over limestone, another 14 percent on 7 percent slopes. Bradyville, at 12 percent, is a deep soil from limestone where the digging stays in clay. With four series this evenly split, rock can show at the surface on one rise and be out of reach on the next.

That unevenness is why a tract gets walked before a pad location is fixed. Moving a house or barn site off a ledge onto deeper Cumberland or Bradyville ground can save a lot of hammer time, and a test hole answers the question faster than a guess. Where the rock cannot be avoided, the excavator carries a hammer for excavation through it.

When does clearing land in Walterhill need a county permit?

When the clearing, grading or excavating covers more than an acre. Rutherford County’s land disturbance permit applies above that size, and its office is reached at 615-898-7732. An acre is 43,560 square feet, roughly a square 209 feet on a side, and a homesite with its drive, yard and septic area can pass that faster than an owner expects.

The state’s TNR100000 construction stormwater permit begins at one acre as well. Debris from land clearing can be burned only with a free permit from BurnSafeTN.org between October 15 and May 15, good only on the day it is issued. Forestry mulching is the other way to deal with brush, grinding it where it stands and leaving it on the ground as a mat instead of a pile.

How far is Walterhill from Brentwood?

Walterhill is about 22.7 miles from Brentwood in a straight line, inside the 30 miles the company works. Lascassas and Murfreesboro have pages here as well. A clearing or pad job on acreage is easiest to price from a few pictures, a rough outline of the area, and a note on what is going to be built. The scope and what will be disturbed get agreed before a machine is unloaded. Tennessee 811 applies on open land too, since power and water lines cross rural tracts, and the ticket wants 3 working days’ notice.

Answers

Walterhill questions

How big is Walterhill, TN?

Small. The census counts 113 people and 44 homes in the Walterhill census area, with a median build year of 1997 and about a third built in 2010 or later. With so few houses, the ground matters more than the housing for dirt work here: which soil a tract sits on decides most of what a pad, drive or trench involves.

Is red Cumberland clay good fill for a building pad in Walterhill?

It can be, if it goes in at the right moisture and in thin lifts. Cumberland is the most common soil around Walterhill, a dark red clay below a silt loam surface. Placed in 1-foot lifts and rolled, clay like that holds a pad well. Too wet, it ruts and pumps; too dry, it will not compact properly.

Can you put a gravel driveway across land in Walterhill?

Yes. A new drive starts with stripping the topsoil along its path, grading a crown or a cross slope so water leaves the surface, and placing a compacted stone base. On Walterhill’s red clay and shallow limestone, the base thickness and the ditches beside the drive matter more than the top layer of gravel.

Can you clear land in Walterhill without burning the brush?

Yes. Brush and small trees can be ground in place with forestry mulching, or hauled off the property. Burning is legal from October 15 to May 15 only with a free daily permit from BurnSafeTN.org. Large trunks and stumps are handled separately, cut and removed or ground down, so the cleared ground is ready to grade.

Don’t wait until it gets worse

Send us a picture. Get a free estimate.

A phone photo of the yard, the wall or the wet corner tells us most of what we need before anyone drives out.

Call Free Estimate