(615) 569-1679 Veteran-owned · Licensed and insured · Since 2021 brentwooddirtworks@gmail.com

Davidson County · 15.1 miles from Brentwood

Excavation on Hermitage’s limestone ground

All four of the most common soils near Hermitage’s center formed over limestone, and that shapes how a trench or a footing goes.

Brentwood Hermitage 30 miles 20 10

TL;DR

Hermitage is a Metro Nashville community in Davidson County, about 15 miles from Brentwood; its 37076 ZIP area has 39,017 people in 19,456 homes, median year 1991. Talbott, Hampshire, Lomond and Bradyville, the four soils most common near its center, all formed over limestone. That means rock in some trenches and footings, clay that drains slowly, and a reason to ask Metro’s sinkhole question before grading. Trenching, drainage and pads are the jobs that ground shapes most.

How close is rock to the surface in Hermitage?

Close enough to plan for in some spots. Talbott, the soil at 29 percent of the sample points near Hermitage’s center, is a moderately deep clay weathered from limestone, so a trench or footing can reach rock within a few feet. Hampshire, at 13 percent, is deep, and Lomond and Bradyville, at 10 and 9 percent, are deep soils over limestone residuum on gentler 4 percent slopes.

When the bucket meets ledge, a hammer on the excavator breaks it and the pieces come out. The schedule and the scope get talked through with you at that point, before the job goes further, so the rock never shows up first on an invoice.

Why does Metro ask whether a Hermitage job drains to a sinkhole?

Because limestone dissolves, and water running into a sinkhole goes into the rock without being filtered. On the Metro grading permit page, a job skips the permit only if, among other things, it does not sit in a watershed that drains to a sinkhole. Grading changes where runoff goes, so a yard that drains into one carries more risk than the same yard draining to a ditch.

Ground formed from limestone, as all four of Hermitage’s main soils are, is the kind where sinkholes occur. A depression that holds water and then drains suddenly, or a hole that opens after heavy rain, is worth a call before any grading starts. The rest of Metro’s conditions are on our Nashville page.

What does trenching look like in Hermitage clay?

Slow in the rocky stretches and steady in the rest. A utility trench for a water line, an electrical feed or a sewer lateral starts with a Tennessee 811 ticket three working days ahead, then GPS locators for the private lines 811 does not cover. The pipe laser holds the grade along the bottom, which matters for a gravity sewer or drain that has to fall the whole way.

Talbott’s clay has moderately slow permeability, and a trench backfilled with loose spoil becomes a channel that carries water along the pipe. Backfill goes back in compacted layers so the line stays covered and the lawn does not sink along it a season later.

What else does Hermitage ground call for?

Drains on the clay and careful pads on the slopes. Hampshire ground near the center has a median slope of 16 percent, steep enough that a garage or shed pad needs a cut on one side and compacted fill on the other, built up in 1-foot lifts. On the flatter Talbott and Bradyville clay, a yard that holds water usually wants a French drain or a regrade.

Lomond, formed in loess and alluvium over limestone on 4 percent ground, is the easiest of the four to dig. Housing in the 37076 ZIP area is mixed too: 37 percent built in 2000 or later and 28 percent before 1980, so a call is as likely to be about a compacted new yard as an old lateral.

Hermitage is about 15 miles from our Brentwood base. Send a picture of the job for a free estimate, and we will agree with you on the scope and on what gets disturbed before anything is scheduled.

Answers

Hermitage questions

Are there sinkholes in Hermitage, TN?

The soils say it is the kind of ground where they form, since Talbott, Hampshire, Lomond and Bradyville all developed over limestone. Whether one affects your lot is a site question. Metro’s grading test asks whether a job drains to a sinkhole, and a yes means the job needs a permit.

Can you trench through rock in Hermitage?

Yes. The excavator’s hammer breaks ledge in the trench line, and the pipe laser keeps the bottom on grade where the rock has been broken out. Talbott, the most common soil near Hermitage’s center, is only moderately deep, so a long trench there may cross rock for part of its run.

What should I do about a low spot in my Hermitage yard?

Get it looked at before anyone fills it. A low spot on Hermitage’s limestone soils can be settled fill, a crushed drain or the start of a sinkhole, and each is fixed differently. Send a picture and tell us whether it holds water or drains suddenly, since that points toward the cause.

Do you build garage and shed pads in Hermitage?

Yes. On sloped Hermitage ground, a pad is cut on the high side and filled on the low side, with the fill placed in 1-foot lifts and rolled before the next goes on. Laser-controlled grading sets the finished elevation so the slab sits flat and water falls away from it.

Don’t wait until it gets worse

Send us a picture. Get a free estimate.

A phone photo of the yard, the wall or the wet corner tells us most of what we need before anyone drives out.

Call Free Estimate